How to connect Push button to Bollard

To connect a Parklio™ push button to the Bollard, run two wires from the push button contacts to the LO and COM terminals on the Parklio™ Bollard control board.

Refer to the images below for a clear illustration of the connection.

• Related Articles

• Bollard remotes adding and erasing

  Please find all the instructions for adding and erasing bollard remotes:

• How to connect Master and Slave bollard

  Please look at the wiring diagram how to connect Master and slave bollard: Also some programming is needed: In this case you just install photocells for master bollard.

• How to connect push button for Bollards

• How to connect LMP+ wire on Bollard

  On next picture you can see where to connect LMP+ wire when installing bollard:

• How to connect Photocells to Bollard

  You should have two photocells and two transmitters per bollard. Transmitter is just for signal and it is battery driven, you should only install batteries inside and close cap. In the instructions there are wires but it is not necessary in your ...