How to connect LMP+ wire on Bollard

On next picture you can see where to connect LMP+ wire when installing bollard:

• Related Articles

• How to connect Master and Slave bollard

  Please look at the wiring diagram how to connect Master and slave bollard: Also some programming is needed: In this case you just install photocells for master bollard.

• How to connect Push button to Bollard

  To connect a Parklio™ push button to the Bollard, run two wires from the push button contacts to the LO and COM terminals on the Parklio™ Bollard control board. Refer to the images below for a clear illustration of the connection.

• How to Connect Photocells to Bollard

  You should have two photocells and two transmitters per bollard. Transmitter is just for signal and it is battery driven, you should only install batteries inside and close cap. In the instructions there are wires but it is not necessary in your ...

• Bollard remotes adding, erasing & programming

  Please find all the instructions for adding and erasing bollard remotes: Instructions for programming the remote control: Press the MENU button. This should take you to the P menu. Use the arrow buttons until you reach option P9. Press MENU, and 00 ...

• Bollard Solar kit - Electrical connections and Junction box

  Junction box mounting Mount the Junction box vertically on a non-flammable substrate, with the electrical terminals facing downward. The Dimensions drawings chapter of this manual contains a dimension drawing of the solar panels and Junction box. ...