Bollard remotes adding, erasing & programming

Please find all the instructions for adding and erasing bollard remotes:

Instructions for programming the remote control:

Press the MENU button. This should take you to the P menu.
Use the arrow buttons until you reach option P9.
Press MENU, and 00 will appear on the display.
Press the button on the remote control you want to program (the remotes must be programmed one by one).
Press MENU to return to the P menu.
Press the up and down arrows at the same time to exit the menu, then test the remote control.

• Related Articles

• How to connect Master and Slave bollard

  Please look at the wiring diagram how to connect Master and slave bollard: Also some programming is needed: In this case you just install photocells for master bollard.

• Adding keyfob for the bollard

  To access the P menu press the MENU button for 1 sec. Use up and down arrows to navigate through the menus. Go to P9 Press MENU will appear . Press MENU to edit the value. Use UP and DW to change the value. Press MENU to save the new value. Press ...

• Bollard installation - standard model

  Please be aware that all installation instructions have to be respected for your warranty to be valid. A - Sewer B - Sand C - Cement The pre installation process involves digging a hole, installing drainage for water runoff, threading the cable ...

• Bollard photocells

  Two pairs of photocells are always delivered together with Parklio Bollard device and connected to the control box using a UTP cable. Every photocell has its own transmitter that must be installed on site depending on the Bollard desired position. ...

• Bollard Control Box Overview

  Each bollard is delivered with a control box responsible for powering and controlling the device. The control box manages the electrical supply and communication required for the bollard to operate properly. Control Box Dimensions The dimensions of ...