How to connect e- loop receiver to Gate

To connect e-loop to Parklio Gate please refer to the images below for a clear illustration of the connection:

• Related Articles

• How to connect magnetic loop e-Trans 100 to Parklio Gate

• How to connect Push button to Gate

  To connect a Parklio™ push button to the Gate, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate control board. This wiring setup applies only when the push button is intended for opening the Gate. Refer to ...

• Programming remotes for Gate

  If client bought remote controller after receiving Gate it should be programmed first. Remote for Gate is programmed directly to Gate control board , more precisely receiver, and can not be programmed over App. To program remote control to Gate , ...

• How to connect Push button to Gate X

  To connect a Parklio™ push button to the Gate X, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate X control board. Refer to the images below for a clear illustration of the connection.

• How to connect antenna 433 on Gate

  On pictures you can find right way to connect antenna. Connection on top cover has to be waterproof.