How to connect Parklio Gate X with Parklio QR reader

To connect QR reader to Parklio Gate X please refer to the images below for a clear illustration of the connection:

• Related Articles

• How to connect Parklio Gate with Parklio QR reader

  To connect QR reader to Parklio Gate please refer to the images below for a clear illustration of the connection:

• Parklio flashing light to Gate X connection

  This article provides wiring diagrams for connecting a Parklio flashing light, or a flashing light from another manufacturer, to Gate X. Important: These wiring diagrams apply only if Gate X does not have an LED stripe connected. If the user is using ...

• How to connect Push button to Gate X

  To connect a Parklio™ push button to the Gate X, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate X control board. Refer to the images below for a clear illustration of the connection.

• Connecting LED stripe to Gate X

  Connecting an LED Strip to Gate X To connect an LED strip to Gate X, an additional relay must be installed if the client requires advanced LED strip functionality. This allows the LED strip to operate based on specific barrier states or logic. Below ...

• Poor Reception on Parklio Gate

  Under typical urban operating conditions, the expected communication range of the Parklio Gate antenna is approximately 30–50 meters via Bluetooth and up to 20 meters via remote controller. In optimal conditions, the maximum range of both connection ...