LE & LA Error on Parklio Bollard

Bollards are programmed not to work without photocells and if they are not installed you get LE or LA Error and Bollard can not work. 

- LE error means photocell 1 is not installed. 

- LA error means photocell 2 is not installed.

• Related Articles

• How to connect Master and Slave bollard

  Please look at the wiring diagram how to connect Master and slave bollard: Also some programming is needed: In this case you just install photocells for master bollard.

• Bollard remotes adding, erasing & programming

  Please find all the instructions for adding and erasing bollard remotes: Instructions for programming the remote control: Press the MENU button. This should take you to the P menu. Use the arrow buttons until you reach option P9. Press MENU, and 00 ...

• Parklio Bollard K8 and PAS68 rating

  Parklio Bollard is not rated with K8 or PAS 68 certifications, as it is not designed for anti-terrorist purposes

• How to Connect Photocells to Bollard

  You should have two photocells and two transmitters per bollard. Transmitter is just for signal and it is battery driven, you should only install batteries inside and close cap. In the instructions there are wires but it is not necessary in your ...

• Bollard photocells

  Two pairs of photocells are always delivered together with Parklio Bollard device and connected to the control box using a UTP cable. Every photocell has its own transmitter that must be installed on site depending on the Bollard desired position. ...