Tube installation for Barrier

• Related Articles

• Adding Keyfob to Barrier

  Before adding keyfob enable Bluetooth, location and internet access on mobile phone. To add new keyfob follow next procedure: 1. Connect to barrier 2. In settings click Add keyfob options 3. Press and hold button on receiver until LED light on top of ...

• Barrier operates too slow

  If the barrier goes too slowly, charge the battery; if that does not help, update the barrier firmware through the barrier settings: Connect to Barrier Go to Settings Put mobile phone on the Barrier case Click update firmware if the Update link ...

• Barrier is jammed

  If your barrier is jammed there could be multiple reasons and solutions. First check if your barrier is hit, there could be deformations in safety pin and arch and in that case only installing new parts can resolve situation. Also if you barrier is ...

• Key exchange error

  SCAN_FAILED_DEVICE_NOT_FOUND The phone was not able to find the device during a rescan. This might go away by simply retrying again. If not, ensure that the device is properly connected. Also ensure that the device has the LOCATION PERMISSIONS needed ...

• Barrier connection for the first time

  Ensure that the battery is fully charged. Devices come with a battery charged to 20% due to transportation legislation and optimum cold storage values. When the device battery is connected to the barrier, the LED should blink with a green light. ...