There is no internet connection to ANPR

If your ANPR works in HIK interface but can not connect to Parklio PMS system it is probably because your internet connection has firewall.

If the network has a firewall enabled you may need to enable the camera to access the remote hosts. The list  of services is provided below:

Please keep in mind that the hosts can resolve to multiple IP addresses, which can change at any time.

• Related Articles

• How to connect ANPR to Parklio product (hardware)

  On the pictures below you can see connection between Parklio ANPR and any other product. This step is important during installation as all connection have to be exact like this: ANPR can be powered by POE (Power over internet) or adapter. Adapter is ...

• ANPR package content

  Before installing the camera read the quick installation guide included in the camera box. The camera package should contain the following items: 1x ANPR Camera 1x QR Code 8x Waterproof tape 4x Mounting screws with dowels 1x Cable gland 1x Allen ...

• Parklio devices and connection to ANPR

  Parklio Gate: Connect the camera ALARM terminals (terminals 1A and 1B) to AP and COM (6) terminals on the Gate control electronics. Note: When using the camera, it is recommended to enable automatic closing of the gate Parklio Bollard: Connect the ...

• Supported license plates for ANPR camera

  ANPR camera can support all license plates on list below and if your country is not on the list that means you probably need special firmware for camera. In that case you need to address in which country camera would be used to our sales department ...

• ANPR installation

  Installation Angle The installation angle must meet the requirements below: • The Vertical angle should not exceed 30 degrees. • The Horizontal angle should not exceed 30 degrees Installation height and distance The camera Height (H) should be 1,6m ...