Standard (STAND ALONE) Acquisition Procedure
This process is important to do after adjusting spring on Gates. To do acquisition procedure follow next steps:
1. Your arm is locked and in down position.
2. Press and hold PROG for 4 seconds. APP - is shown on the display.
You can also find the photo of pressing and holding PROG for 4 seconds on the Parklio Gate at the following link:
3. Unlock arm (there are two types of locks)
You can also find the photo of unlocking the arm on the Parklio Gate at the following link: https://file.parklio.co/file/8zevxbaa8e47793e14563aa2f32ddd14659ae
4. Put arm manually to 45° (if your arm is not standing alone on 45° please check the article https://parklio.zohodesk.eu/portal/en/kb/articles/changing-arm-side)
After a few seconds, the message PHAS is shown on the display. The controller unit launches a calibration procedure. The operating parameters of the motor are determined during calibration. If the motor calibration procedure is successful, the message PHAS flashes on display.
You can also find the photo of PHAS message after calibration is done at the following link: https://file.parklio.co/file/8zevxd13420d8f1494a97a47d454120621650
5. Lock the arm while it is standing on 45°
You can also find the photo of locking the Gate's arm at the following link: https://file.parklio.co/file/8zevxc3ecef3a271a41edb8be7933cbaa93ae
6. The acquisition procedure now starts. The message AUTO is shown on the display and the barrier starts opening at low speed. Once the barrier open mechanical stop is reached, the barrier stops briefly. Message AUTO flashes on the display. The barrier closes until it reaches the barrier closed mechanical stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display mode.
You can also find the photo of acquisition procedure on the Parklio Gate at the following link: https://file.parklio.co/file/8zevx911feda4517144c0a0fbe2fdd662e850