How to connect antenna 433 on Gate

On pictures you can find right way to connect antenna.

Connection on top cover has to be waterproof.

        

• Related Articles

• How to connect Push button to Gate

  To connect a Parklio™ push button to the Gate, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate control board. This wiring setup applies only when the push button is intended for opening the Gate. Refer to ...

• Connecting Timer to Gate - Wiring diagram

  If you purchase Timer after you already received Gate you will need to connect it properly, please find all the detail below: Connect : TIMER Power + / 24 V+ -> GATE +24V (13) TIMER Power - / 24 V- -> GATE COM (12) TIMER COM -> GATE COM (34) TIMER ...

• Gate default settings (control board)

  These are the default settings for the Parklio Gate and should not be altered without consulting Parklio support. You should only check these settings if the Gate isn’t functioning correctly. Any necessary adjustments will be made at our production ...

• Connecting arm LED light for Gate

  To connect Gate arm LED light to control board you need to do next: 1. Connect red wire from LED light to LUC(+) 2. Connect black wire from LED light to COM(+) Connectors are marked on picture with red circle:

• Connecting LED stripe to Gate X

  Connecting an LED Strip to Gate X To connect an LED strip to Gate X, an additional relay must be installed if the client requires advanced LED strip functionality. This allows the LED strip to operate based on specific barrier states or logic. Below ...