How to Connect Photocells
For all Gates we use Hiland P5141 Photocells. They are connected on Gate's control board like this:
1. Power supply
From 12V-24V to 24 (Nr. 14) and COM (Nr. 13)
Photo of connection between Parklio Gate's control board and Photocells is avliable at the following link: https://file.parklio.co/file/bdj1he5baed94868547ffa5a59228447b2c49
2. Signal
From Photo to COM (Nr. 25) i FT(Nr. 24)
Photo of connection between Parklio Gate's control board sygnal port and Photocells is avliable at the following link: https://file.parklio.co/file/bdj1he0a81e50bce742f29f752e5acaf6b797
Related Articles
How to Connect Push Button to Gate
To connect a Parklio™ push button to the Gate, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate control board. This wiring setup applies only when the push button is intended for opening the Gate. Refer to ...How to Connect a 433 MHz Antenna to the Gate
The following photos show the correct way to connect the 433 antenna. The connection on top must be waterproof. You can also find a photo showing the connection of a 433 MHz Antenna to the Gate: ...How to Connect Parklio Gate X With Parklio QR Reader
To connect QR reader to Parklio Gate X please refer to the images below for a clear illustration of the connection: A photo of the wiring diagram between the Parklio Gate X and the Parklio QR Reader is available at the link below: ...How to Connect Parklio Gate With Parklio QR Reader
To connect QR reader to Parklio Gate please refer to the images below for a clear illustration of the connection: Photo of a wiring diagram between Parklio Gate and Parklio QR Reader is avaliable on the link below: ...How to Connect Push Button to Gate X
To connect a Parklio™ push button to the Gate X, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate X control board. Refer to the images below for a clear illustration of the connection. A photo of the wiring ...