Powering the Parklio Chain Barrier

Powering the Parklio Chain Barrier

After installation, the Parklio Chain Barrier must be connected to a power supply. Please follow the instructions below to ensure correct setup.

1. Powering the Master Unit

  • The master unit operates on a 230V power supply.

  • Refer to the image provided to locate the power input point on the master unit.

  • ⚠️ If your site uses a 110V power grid, a transformer is required.

    • This should be communicated to the Parklio Sales Department before purchase.

    • Alternatively, you may use a suitable transformer of your own.

2. Connecting the Slave Unit

  • The slave unit is powered directly from the master unit.

  • Ensure all necessary connection cables are installed before mounting the chain columns.

  • The diagram shows the correct terminal location for connecting the slave unit motor.

3. Synchronized Operation

  • The slave motor operates in sync with the master unit.

  • No separate controls are required — the system functions automatically once connected.