Parklio Chain - No option in App

If you have screen like this for Parklio Chain, you should check IO0 and IO1 connections on Parklio Brain and Chain's control board. It is probably loose contact. Secure it and try again. 

• Related Articles

• Chain stops halfway on automatic mode

  If the chain doesn’t go all the way up or down as it should when controlling the App, the problem is probably in switches inside the chain. Switches must be inspected and returned to their own position. There are two switches behind inner chain in ...

• Chain is not rising or barely rising

  A possible solution for this problem is to first increase the torque on the motor and do the calibration process after that. Note: If the torque screw is set to maximum then the potentiometer will got minimum and the torque will be lowered instead of ...

• How to install Chain Column

  Instructions for installing Chain column: 1. Screw in for 1,5 - 2,0 cm the 4 screws M10x70 in dotation to the base. 2. Place the base on the previously prepared base of cement (Fig.3) 3. The upper part of the base should be clean and perfectly ...

• Chain does not receive commands from App or PMS

  If you installed Chain and manual mode is working well, also you get true positions of Chain in App, but when you click lower or extend nothing is happening, please try next: On Parklio Brain device disconnect wire from -(minus, red on picture) and ...

• Manual control of the Chain

  Move the Chain to Manual mode on control board Press the yellow button to rise the chain and the blue one to lower it