Manual Control of The Chain

Manual Control of The Chain

  1. Move the Chain to Manual mode on control board (Control board is located in master unit in the white plastic box).

You can see the image of control board modules needed to switch the chain to manual mode at the following link:
https://file.parklio.co/file/fsz0ge2101566c7f54cb3b7f1e60626813b79

2. Press the yellow button to rise the chain and the blue one to lower it.

The Parklio™ Chain is factory pre-calibrated. Calibration is only necessary if the chain length has been altered or if transport and installation have affected calibration so the manual mode is not important for callibration process.