LED Light is Blinking Twice in a Sequnce
If the LED on the reset button blinks twice in a row, it usually means that the accelerometer cable has become disconnected. This can happen when inserting the Safety Pin if the user lifts the motor tube too high, which may cause the cable inside the tube to disconnect. This issue is also described in the User Manual.
To resolve it:
- Disassemble the tube as shown in the video:
2. After opening the tube, you will see:
A photo of the cables and connectors inside the motor tube is also provided on the link below:
3. The white connector may become disconnected, so you need to reconnect it as shown in the previous picture.
The easiest way to do this is to use tweezers or a similar tool.
Related Articles
Troubleshooting Guide: Understanding Parklio Barrier LED Indicator
The Parklio Barrier is designed to automatically detect and display most errors. A reset button with an integrated LED light is located on the front side of the electronics box. Normal operation The LED light remains off when the barrier is ...LED Light Constantly On or Constantly Off – Troubleshooting Guide
If the LED light on the Barrier is constantly on (not blinking) or constantly off, this may indicate a hardware issue. There are several possible causes that should be checked in the following order. Possible Causes and How to Check 1. Cover Issue In ...Barrier LED Light Error List
If you are experiencing troubleshooting during usage of Barrier you can check LED light on electronic box which can give you description of hardware problem if there is any. LED light will blink in certain sequence and you can find explanation in ...LED is On all The Time - Older Version of the Barrier
If the LED light is constantly green, it likely indicates a hardware issue that is preventing the Barrier from functioning properly until resolved. This is usually related to either the motor tube or the cover (which contains the solar panel, sensor, ...Adding a Keyfob to a Barrier
Before adding a Keyfob, make sure Bluetooth, Location, and internet access are enabled on your mobile phone. To add a new Keyfob, follow these steps: Connect to the Barrier. In Settings, tap Add Keyfob. Press and hold the button on the receiver until ...