How to Install Extensions for Barrier?

On the pictures below you can see how to install extension on the Barrier. When you order an extension along with a Barrier, the Barrier will already have pre-drilled holes, allowing you to simply screw in the extension. If you order extension afterward, there will be no holes on Barrier and they need to be drilled according to picture above.

You can also find the photo of extension for the Barrier on the following link: https://file.parklio.co/file/omc96bb090c83304146b891557f9a6dad0788.

• Related Articles

• Adding a Keyfob to a Barrier

  Before adding a Keyfob, make sure Bluetooth, Location, and internet access are enabled on your mobile phone. To add a new Keyfob, follow these steps: Connect to the Barrier. In Settings, tap Add Keyfob. Press and hold the button on the receiver until ...

• Key Exchange Error

  SCAN_FAILED_DEVICE_NOT_FOUND The phone was not able to find the device during a rescan. This might go away by simply retrying again. If not, ensure that the device is properly connected. Also ensure that the device has the LOCATION PERMISSIONS needed ...

• How to Resolve the “Dirty Sensor” Error

  After cleaning the device sensor, the device sensor does not automatically change the state since the laser is only triggered by environmental changes to preserve battery life. Steps to remove the error: Remove any obstruction on the laser Clean the ...

• The Barrier Is Jammed

  If your Barrier is jammed there could be multiple reasons and solutions. First check if your Barrier is hit, there could be deformations in Safety Pin and arch and in that case only installing new parts can resolve situation. Also if you Barrier is ...

• Barrier Motor Tube Issues

  If the Barrier is moving very slowly, not lifting at all, or getting jammed frequently, the motor tube may be the source of the problem. Slow movement usually indicates that the motor tube is wearing out, while the Barrier that does not lift at all ...