How to install Chain Column

Instructions for installing Chain column:

1. Screw in for 1,5 - 2,0 cm the 4 screws M10x70 in dotation to the base.

2. Place the base on the previously prepared base of cement (Fig.3)

3. The upper part of the base should be clean and perfectly horizontal.

4. Pass the plastic tubes of the cables through the central opening on the base and    check again the stability of the base.

5. Unscrew the 8 screws [10] take off the frontal [8] and the rear cover [9] of the    column (Fig. 4 )

6. Place now the column structure on the base.

7. Fix now the column to the base with the 4 washers [5] and 4 nuts [4].

8. Fix the frontal covers [8] of both columns with 4 screws [10].

9. Now you can fix the chain to the apposite holes on both columns respecting the    level X in the middle of the chain barrier indicated at the table on page 1 (Fig. 5)

Please note that installation cables are not included with the product as the appropriate cable length varies depending on the specific requirements of your installation site. To ensure a seamless installation, we advise consulting with your installer or a qualified professional who can accurately assess and calculate the appropriate cable length required for the Chain installation at your specific location. 

• Related Articles

• Chain stops halfway on automatic mode

  If the chain doesn’t go all the way up or down as it should when controlling the App, the problem is probably in switches inside the chain. Switches must be inspected and returned to their own position. There are two switches behind inner chain in ...

• Chain is not rising or barely rising

  A possible solution for this problem is to first increase the torque on the motor and do the calibration process after that. Note: If the torque screw is set to maximum then the potentiometer will got minimum and the torque will be lowered instead of ...

• Manual control of the Chain

  Move the Chain to Manual mode on control board Press the yellow button to rise the chain and the blue one to lower it

• Parklio Chain - No option in App

  If you have screen like this for Parklio Chain, you should check IO0 and IO1 connections on Parklio Brain and Chain's control board. It is probably loose contact. Secure it and try again.

• How to add remote for Chain

  Press and release the RED button. The flashing LED will remain constantly lit. IF NOT - Check that the chain is completely closed (UP) and that the SW1 is in position AUTO, repeat again from the beginning. Press the 1st button on the remote control. ...