How to reset Barrier
To perform reset of Barrier please follow next steps:
- Open cover with solar panel using key
- Inside there are two boxes, electronic box and battery
- On electronic box there is reset button
- Press reset button until LED light on button shows up and then release it
- When LED light is off your barrier is reset successfully
Related Articles
Key exchange error
SCAN_FAILED_DEVICE_NOT_FOUND The phone was not able to find the device during a rescan. This might go away by simply retrying again. If not, ensure that the device is properly connected. Also ensure that the device has the LOCATION PERMISSIONS needed ...Manually updating firmware on barrier
If the standard firmware update is not working for any reason, you can update the firmware manually using your mobile phone. This manual process requires: The Manual Firmware Update PDF (attached) The latest firmware ZIP file (attached or ...Troubleshooting Guide: Understanding Parklio Barrier LED Indicator
The Parklio Barrier is designed to diagnose and display most errors autonomously. Located on the front side of the electronic box is a reset button with an integrated LED light. Normal Operation: The LED light remains off when the barrier is ...LED is on all the time - Older version of barrier
If the LED light is constantly green, it likely indicates a hardware issue, preventing the barrier from functioning properly until the problem is resolved. There is usually problem with motor tube or cover, which contains solar panel, sensor etc. ...Error Message: “Something Went Wrong” When Adding a Barrier in the Parklio App
What to Do 1. Check the LED Indicator The client should check the LED light status on the barrier according to the official instructions available here: https://support.parklio.com/portal/en/kb/articles/how-to-check-error-on-barrier The LED signal ...