How to Replace the Electronic Box on Your Parklio Barrier

How to Replace the Electronic Box on Your Parklio Barrier

If you need to replace the electronic box inside your Parklio Barrier, follow the step-by-step video guide available at the link below:

🔗 Watch the Video Guide

Important Notes:

  • The video demonstrates the disassembly process only.
  • To install the new electronic box, simply follow the steps in reverse order.
  • This is the only correct method to ensure proper installation and to maintain the device's warranty.

For further assistance, please contact Parklio Support at support@parklio.com.


    • Related Articles

    • Troubleshooting Guide: Understanding Parklio Barrier LED Indicator

      The Parklio Barrier is designed to automatically detect and display most errors. A reset button with an integrated LED light is located on the front side of the electronics box. Normal operation The LED light remains off when the barrier is ...

    • How to Connect Parklio™ Parking Barriers with Universal Remote Controllers

      To enable control of your Parklio™ Barrier using universal remote controllers, please follow the steps below carefully: Step 1: Update the Barrier Firmware Make sure that your Barrier firmware is updated to version 1.4.15 You can preform the update ...

    • Key Exchange Error

      SCAN_FAILED_DEVICE_NOT_FOUND The phone was not able to find the device during a rescan. This might go away by simply retrying again. If not, ensure that the device is properly connected. Also ensure that the device has the LOCATION PERMISSIONS needed ...

    • How to Reset the Parklio Barrier

      To perform a reset of the Barrier, please follow the next steps: Open the cover with the solar panel using the key. Inside, there are two boxes: the electronic box and the battery. On the electronic box, there is a reset button. Press the reset ...

    • How to Resolve the “Dirty Sensor” Error

      After cleaning the device sensor, the device sensor does not automatically change the state since the laser is only triggered by environmental changes to preserve battery life. Steps to remove the error: Remove any obstruction on the laser Clean the ...