How to Connect a Timer to Disable the Brain Unit
If the client wants to use a timer to disable Brain usage on the Gate, they should connect the timer as shown in the diagram:
In this case, when the N.C. contact is connected to AP, it will be possible to use Brain with the app while the timer is on.
If the N.O. contact is connected to AP, it will not be possible to use Brain with the app while the timer is on.
The Gate remote controls will work in all scenarios.
Related Articles
Connecting Timer to the Gate - Wiring Diagram
If you purchase the Timer after you have already received the Gate, you will need to connect it properly. Please find all the details below: Connect : TIMER Power + / 24 V+ -> GATE +24V (13) TIMER Power - / 24 V- -> GATE COM (12) TIMER COM -> GATE ...
Connecting Brain Device to the Gate - Wiring Diagram
Please find below all the details for connecting the Brain to the Gate: You can also find a photo showing the wiring diagram between the Parklio Gate and Parklio Brain at the following link: ...
How to Connect Push Button to Gate X
To connect a Parklio™ push button to the Gate X, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate X control board. Refer to the images below for a clear illustration of the connection. A photo of the wiring ...
How to Connect Two Gates to Operate Simultaneously
To synchronize two gates so they operate at the same time, follow these steps: 1. Connect the Bus Terminals Begin by connecting the bus terminals of the master and slave control units. Important: Ensure that both control units are powered off, and ...
How to Connect Push Button to Gate
To connect a Parklio™ push button to the Gate, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate control board. This wiring setup applies only when the push button is intended for opening the Gate. Refer to ...