How to Add Remote for Chain

How to Add Remote for Chain

Press and release the RED button. The flashing LED will remain constantly lit.
↳ IF NOT - Check that the chain is completely closed (UP) and that the SW1 is in position AUTO, repeat again from the beginning.

Press the 1st button on the remote control. The flashing signal emits 2 slow flashes followed by a fast flash.
↳ IF NOT - If the flashing signal has emitted 1 slow flash followed by 1 fast flash, the button pressed was already memorized and you can continue with the procedure. Contrarily check that the remote control is working, that it has the same decoding set in the control unit and that the radio module is inserted. At this stage repeat the test.

The 1st button is memorized. Press and release the RED button. The flashing LED will remain constantly lit.
↳ IF NOT - Check that the chain is completely up and that SW1 is in the AUTO position and repeat the test.

Press the 2nd button on the remote control. The flashing signal emits one slow flash followed by 1 fast flash.
↳ IF NOT - Check that the remote control is working, that it has the same decoding set in the control panel and that the radio module is inserted. At this stage repeat the test.

The 2 buttons are memorized and the procedure ends.

    • Related Articles

    • Chain is not rising or barely rising

      A possible solution for this problem is to first increase the torque on the motor and do the calibration process after that. Note: If the torque screw is set to maximum then the potentiometer will got minimum and the torque will be lowered instead of ...

    • Chain Stops Halfway in Automatic Mode

      If the chain doesn’t go all the way up or down as it should when controlling the App, the problem is probably in switches inside the chain. Switches must be inspected and returned to their own position. There are two switches behind inner chain in ...

    • How to install Chain Column

      Instructions for installing Chain column: 1. Screw in for 1,5 - 2,0 cm the 4 screws M10x70 in dotation to the base. 2. Place the base on the previously prepared base of cement (Fig.3) 3. The upper part of the base should be clean and perfectly ...

    • Parklio Chain - Possible Problems And Solutions

      Type of problem Probable cause Solution On activating the opening command the automation does not move. Lack of electrical power supply Check the presence of the electrical voltage and all the connections to the electrical network. On activating the ...

    • Parklio Chain - Optimum Height of Chain Depending on Chain Lenght

      The Parklio Chain consists of the following main components: Parking post Control unit Profile for the chain Chain You can also find the image of components of Parklio Chain at the following link: ...