Parklio Chain - Factory Reset

Parklio Chain - Factory Reset

To successfully reset the Parklio Chain, follow the instructions below:

  1. Power off the chain (remove power supply).

  2. Press and hold the RED button.

  3. Reconnect the power supply while the RED button is pressed.

  4. The LED will start to flash, keep the RED button pressed until the LED lights up for the 3rd time.

  5. Release the button and wait for the LED to turn off.

  6. Reset is complete.

    • Related Articles

    • Chain is not rising or barely rising

      A possible solution for this problem is to first increase the torque on the motor and do the calibration process after that. Note: If the torque screw is set to maximum then the potentiometer will got minimum and the torque will be lowered instead of ...

    • Chain Stops Halfway in Automatic Mode

      If the chain doesn’t go all the way up or down as it should when controlling the App, the problem is probably in switches inside the chain. Switches must be inspected and returned to their own position. There are two switches behind inner chain in ...

    • How to install Chain Column

      Instructions for installing Chain column: 1. Screw in for 1,5 - 2,0 cm the 4 screws M10x70 in dotation to the base. 2. Place the base on the previously prepared base of cement (Fig.3) 3. The upper part of the base should be clean and perfectly ...

    • Manual Control of The Chain

      Move the Chain to Manual mode on control board (Control board is located in master unit in the white plastic box). You can see the image of control board modules needed to switch the chain to manual mode at the following link: ...

    • Parklio Chain - Optimum Height of Chain Depending on Chain Lenght

      The Parklio Chain consists of the following main components: Parking post Control unit Profile for the chain Chain You can also find the image of components of Parklio Chain at the following link: ...