Alarms and Faults on Display Inside The Gate
There are several errors that may be displayed on the Gate control board. Please find below an explanation of each error and possible solutions.
If you are not familiar with this type of procedure, please contact Parklio Support for assistance by email or video call.
You can also find photos of alarms and faults on display inside the gate at the following links:
Related Articles
Solar Gate - Display and Function Buttons
When the display is not lit up, press any of the keys around it to reactivate the back-lighting; when it is already lit up, press a key to navigate the menus and activate automatic switch-off after 60 seconds. If the display switches off (standby), ...Poor Reception on Parklio Gate
Under typical urban operating conditions, the expected communication range of the Parklio Gate antenna is approximately 30–50 meters via Bluetooth and up to 20 meters via remote controller. In optimal conditions, the maximum range of both connection ...Gate Opens and Closes Uncontrollably
If a Parklio Gate begins to open and close uncontrollably after a period of normal operation, the most common causes are either the photocells or the Gate configuration itself. In most cases, the first step is to check whether the photocells are ...Gate X Position Check and Calibration Guide
Before starting the calibration process, it is necessary to check whether the Gate arm can remain on its own at a 45° angle. A sketch of the pre-calibration positioning of the Gate arm at a 45° angle is available at the link below: ...The Display is Showing a "STOP" Error
This happens because the Gate is getting a signal that the lock mechanism is opened. The first solution is to check if the Gate is locked properly. Important: A Gate with a 4m arm can have a different lock mechanism. The second solution is to check ...