Emergency Bollard lowering

In case your bollard is not working properly and you need to get it lowered, use physical keys you got with your Parklio Bollard to unlock the Bollard and lower it manually.

After unlocking, the Parklio Bollard will descend automatically.

In case of power outage, the bollard is prevented by a battery that has enough   power to make one maneuver (open or close). You shall not use the bollard any   more until there is a power supply at 230V because the battery was designed for emergencies only.  

In case of power outage, the bollard is prevented by a battery that has enough   power to make one maneuver (open or close). You shall not use the bollard any   more until there is a power supply at 230V because the battery was designed for emergencies only.  

In case of malfunction of the equipment, you shall call a qualified technician

• Related Articles

• How to connect Master and Slave bollard

  Please look at the wiring diagram how to connect Master and slave bollard: Also some programming is needed: In this case you just install photocells for master bollard.

• Bollard remotes adding and erasing

  Please find all the instructions for adding and erasing bollard remotes:

• Bollard photocells

  Two pairs of photocells are always delivered together with Parklio Bollard device and connected to the control box using a UTP cable. Every photocell has its own transmitter that must be installed on site depending on the Bollard desired position. ...

• Bollard IP rating

  Bollard's IP rating is IP 55. Protected from limited dust ingress. Protected from low pressure water jets from any direction.

• Bollard clicking but not moving

  Check that the Bollard is not in manual mode Check that there is power on the bollard Do the Automatic learning process