Connecting the Arm LED Light to the Gate

To connect the Gate arm LED light to control board you need to do next:

1. Connect red wire from LED light to LUC(+)

2. Connect black wire from LED light to COM(+)

Connectors are marked on picture with red circle:

You can find a photo of connectors for LED Lights on the following link: https://file.parklio.co/file/kq831d6601c15c04045ee9548c2713376ae6a.

• Related Articles

• Parklio Flashing Light to Gate X Connection

  This article provides wiring diagrams for connecting a Parklio flashing light, or a flashing light from another manufacturer, to Gate X. Important: These wiring diagrams apply only if Gate X does not have an LED stripe connected. Photo of a wiring ...

• Using Red/Green LED Strips on The 1-5m Gate Arm

  Using Red/Green LED Strips on the Gate Arm Customers often ask whether they can install a red/green LED strip on the gate arm—for example, red when the Gate is closed and green when it is open—while still using the flashing warning light. ...

• Connecting LED stripe to Gate X

  Connecting an LED Strip to Gate X To connect an LED strip to Gate X, an additional relay must be installed if the client requires advanced LED strip functionality. This allows the LED strip to operate based on specific barrier states or logic. Below ...

• Optimizing Gate Performance: Adjustable Settings for Arm Travel Speed

  When a gate is set up in production and shipped, it comes with factory-adjusted values for arm travel speed, acceleration, and deceleration during opening and closing. However, since clients and parking lots have different layouts and requirements, ...

• Connecting Brain Device to Gate - Wiring Diagram

  Please find below all the details for connecting the Brain to the Gate: For any other questions regarding wiring and connection details, please contact support@parklio.com.