Condensation/water inside solar panel
On some of the barriers it is possible for condensation to form due to differences in outside temperature.
Condensation is not interfering with work of solar panel or barrier so it is not necessary to change panel or whole cover.
Our production team is always working on improvements of products and all the issues will be removed in future.
Related Articles
How to reset Barrier
To perform reset of Barrier please follow next steps: Open cover with solar panel using key Inside there are two boxes, electronic box and battery On electronic box there is reset button Press reset button until LED light on button shows up and then ...
High boot count
In the case of a high boot count, the barrier needs to be fully reset by disconnecting the battery and covering the solar panel for 1 minute. After that, the user should recheck the telemetry in order to see if the problem reappears. If the problem ...
LED is on all the time - Older version of barrier
If the LED light is constantly green, it likely indicates a hardware issue, preventing the barrier from functioning properly until the problem is resolved. There is usually problem with motor tube or cover, which contains solar panel, sensor etc. ...
Error list for LED light on barrier
If you are experiencing troubleshooting during usage of barrier you can check LED light on electronic box which can give you description of hardware problem if there is any. LED light will blink in certain sequence and you can find explanation in ...
Barrier is jammed
If your barrier is jammed there could be multiple reasons and solutions. First check if your barrier is hit, there could be deformations in safety pin and arch and in that case only installing new parts can resolve situation. Also if you barrier is ...