Chain RFID wiring diagram

• Related Articles

• Chain stops halfway on automatic mode

  If the chain doesn’t go all the way up or down as it should when controlling the App, the problem is probably in switches inside the chain. Switches must be inspected and returned to their own position. There are two switches behind inner chain in ...

• Chain is not rising or barely rising

  A possible solution for this problem is to first increase the torque on the motor and do the calibration process after that. Note: If the torque screw is set to maximum then the potentiometer will got minimum and the torque will be lowered instead of ...

• How to install Chain Column

  Instructions for installing Chain column: 1. Screw in for 1,5 - 2,0 cm the 4 screws M10x70 in dotation to the base. 2. Place the base on the previously prepared base of cement (Fig.3) 3. The upper part of the base should be clean and perfectly ...

• Chain Installation Guide: Power Supply, Master/Slave Setup & Photocells

  Before installing the Chain unit itself, it is necessary to complete the power supply installation and connect the master and slave units according to the instructions provided in the user manual. Proper preparation ensures smooth operation and ...

• Electrical connections - Wiring diagram