Adding RFID Cards to the Gate

Adding RFID Cards to the Gate

  1. Turn on RFID.
  2. Begin by placing the first card on the reader. When you hear two beep sounds, the cards has been successfully added.
  3. Repeat the same process for the second card.
  4. Wait 1 minute.
  5. The two cards that were added are now designated as master key cards.
  6. Briefly tap the first master key card on the reader and then add the remaining cards one by one. 
  7. Remember to wait for 1 minute after adding each card before it can be used.


    • Related Articles

    • RFID Wiring diagram for Gate X

      Photo of a wiring diagram between Parklio Gate X and Parklio RFID is available on the link below: https://file.parklio.co/file/fyw2e6bfd7da92c5448fba1abf702c2940ec5

    • RFID Wiring Diagram for a 6-8 m Gate

      Photo of a wiring diagram between Parklio Gate and Parklio RFID is available on the link below: https://file.parklio.co/file/fyw2ebd8da1cd95c94ab6b0380552bc0fa027

    • Parklio Gate Technical Characteristics

      Technical characteristic for Parklio Gate 4: Photo of the table with technical characteristic for Parklio Gate 4 is available on the following link: https://file.parklio.co/file/bdj1h31864cddb6a84ded935abfc3aa8ea72c Technical characteristic for ...

    • Remotes For Gate Specifications

      Technical Specifications of Gate Remote Control Here are the key technical data for the Gate Remote Control: Number of Keys: 2 Number of Code Combinations: 65,536 Transmission Frequency and Modulation: 433.92 MHz AM/ASK Maximum Reach in Unobstructed ...

    • Programming Remotes for the Gate

      If the remote was purchased after the gate was delivered, it must be programmed directly to the gate's control board. To program remote control to Gate, please follow the next procedure: 1. Open the Gate cover and find receiver 2. Press the first ...