Adding a Keyfob to a Barrier

Adding a Keyfob to a Barrier

Before adding a Keyfob, make sure Bluetooth, Location, and internet access are enabled on your mobile phone.

To add a new Keyfob, follow these steps:

  1. Connect to the Barrier.
  2. In Settings, tap Add Keyfob.
  3. Press and hold the button on the receiver until the LED light on top of the remote starts blinking.
  4. Tap Start setup on your phone.
  5. A confirmation message will appear indicating that the Keyfob has been successfully connected.





    • Related Articles

    • Adding a Barrier to the Connect App

      To add a Barrier to the Connect App: 1. Turn on Location, Bluetooth, and mobile data. 2. Open the app. 3. Tap the + icon in the top-right corner. 4. Tap the Barrier you want to add. 5. The Barrier will connect and appear in My Parklios. You can find ...

    • Keyfob Battery Change - Barrier

      To replace the battery in the keyfob, please follow the instructions in the link below: https://drive.google.com/file/d/1E2COe2Cf0fc9YfWmZMvF6YBJ6BjgMHOJ/view?usp=sharing It is important to use something sharp as scalpel.

    • Error Message: “Something Went Wrong” When Adding a Barrier in the Parklio Connect App

      What to Do 1. Check the LED Indicator The client should check the LED light status on the Barrier according to the official instructions available here: https://support.parklio.com/portal/en/kb/articles/how-to-check-error-on-barrier The LED signal ...

    • Key Exchange Error

      SCAN_FAILED_DEVICE_NOT_FOUND The phone was not able to find the device during a rescan. This might go away by simply retrying again. If not, ensure that the device is properly connected. Also ensure that the device has the LOCATION PERMISSIONS needed ...

    • How to Resolve the “Dirty Sensor” Error

      After cleaning the device sensor, the device sensor does not automatically change the state since the laser is only triggered by environmental changes to preserve battery life. Steps to remove the error: Remove any obstruction on the laser Clean the ...