Recent Articles
App Force-Stopped When Sending Command to Gate
If the Parklio Connect App crashes (force stops) when sending an open command to the Gate, it usually indicates that the Permanent Open mode is enabled while the Gate has been manually closed. How to Verify the Issue Open the Gate’s top cover. Locate ...
Understanding the Parklio Barrier I/O Board Power Supply and Voltage Adjustment
The Parklio™ Barrier comes with a dedicated power supply labeled with a nominal output of 12V and 60W. The model name for this power supply is HDR60-12. While it is rated at 12V, the device includes a voltage adjustment feature that allows users to ...
How to connect Push button to Gate
To connect a Parklio™ push button to the Gate, run two wires from the push button contacts to the AP and COM terminals on the Parklio™ Gate control board. This wiring setup applies only when the push button is intended for opening the Gate. Refer to ...
Troubleshooting Calibration Issues on Parklio™ Chain
If you perform a calibration on the Chain barrier but the correct position is not displayed in the app — and you receive messages that the barrier is opening or closing followed by a timeout error — the first step is to check the magnetic switch. How ...
Gate make sounds but does not follow command
If the gate actuator produces a clicking sound upon receiving an open command, but the gate remains closed and the control panel display shows only the power indicator (no other status icons), the issue is likely due to a blown fuse. Refer to the ...